Maximize the life of your Myron L meter’s pH or pH/ORP sensor with Myron L sensor storage solution.
Your meter uses a general-purpose glass pH sensor. This glass sensor may be used in most applications.
To ensure maximum life of your pH meter, read the following procedures. It is the experience of the repair technicians that 90% of all premature pH sensor failures can be prevented with a few maintenance procedures.
The following procedures should be performed after using your meter, or if you plan to store your meter for an extended period of time.
1. The pH sensor well (fig 1) must be filled with storage solution (preferred) or pH buffer 4, or tap water with table salt added and its protective cap (with foam insert) firmly installed.
• Allow the glass membrane to dry out. A dehydrated glass membrane will not produce the necessary “Gel layer” on the sensor surface, which is essential to allow the exchange of hydrogen ions (measure pH).
• Allow airborne contaminants to settle on the glass membrane surface. Once contaminants dry onto the surface of the glass membrane, it will inhibit the transfer of hydrogen ions. (See factory approved cleaning process below.)
• Allow the reference junction to dry out. The reference junction material is usually a wick or fiber type material that completes the electrical circuit between the reference electrode cell and the solution being tested. Dehydration causes the reference solution to leach out of the electrode cavity, and form crystals in the junction. This is normally referred to as the “Bridging effect”.
Repeated dehydration of the pH or pH/ORP sensor will cause the instrument to have a slower response time, and be more difficult to calibrate. Dehydration will significantly reduce the normal service life of the sensor.